Web-Authentication Radius-Server Dead-Interval - Alaxala AX1250S Software Manual

web-authentication radius-server dead-interval

web-authentication radius-server dead-interval
Configures the timer for monitoring automatic restoration to the primary Web authentication
RADIUS server from the Web authentication RADIUS server.
The primary Web authentication RADIUS server is restored when either of the following
occurs: The current server (the destination for RADIUS authentication requests in
operation) switches to a valid secondary Web authentication RADIUS server, or when all
servers are disabled, the monitoring timer starts, and the period of time set by this command
elapses (when the monitoring timer expires).
Input format
To set or change information:
web-authentication radius-server dead-interval
To delete information:
no web-authentication radius-server dead-interval
Input mode
(config)
Parameters
<Minutes>
Sets the timer for monitoring automatic restoration to the primary Wet authentication
RADIUS server from the secondary Web authentication RADIUS server.
1.
2.
Default behavior
The primary Web authentication RADIUS server is automatically restored 10 minutes after
the current server switches to the secondary Web authentication RADIUS server.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
1. If the secondary Web authentication RADIUS server is operating as the current
server, and if the value of the monitoring timer is changed, the progress to that time is
used as the judgment value and the result is applied.
2. If this command configuration is deleted after the monitoring timer starts, the
monitoring timer counter continues without being reset and runs for 10 minutes
(default value).
468
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 1440 (minutes)
If 0 is set, RADIUS authentication requests are always initiated from the
primary Web authentication RADIUS server.
<Minutes>