Authentication Force-Authorized Vlan - Alaxala AX1250S Software Manual

authentication force-authorized vlan

authentication force-authorized vlan
In dynamic VLAN mode of Web authentication and MAC-based authentication, and
port-based authentication (dynamic) for IEEE 802.1X authentication, set this command to
allocate a post-authentication VLAN when forced authentication is performed on the
applicable port.
Input format
To set or change information:
authentication force-authorized vlan
To delete information:
no authentication force-authorized vlan
Input mode
(config-if)
Parameters
<VLAN ID>
Sets a MAC VLAN as the port-authentication VLAN that is assigned when forced
authentication is performed.
1.
2.
Default behavior
The native VLAN of the applicable port is assigned as the post-authentication VLAN.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. The
authentication force-authorized enable
2. When this command is set or deleted, a terminal or a currently authenticated user
operates in the VLAN that was accommodated by the previous setting. The values
set for the
re-authentication or the next authentication.
3. This functionality is not subject to legacy mode.
364
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
See Specifiable values for parameters.
Note, however, that the default
authentication force-authorized vlan
authentication force-authorized vlan
<VLAN ID>
VLAN (VLAN ID = 1)
command is valid only when the
command is set.
command take effect after
cannot be set.