Web-Authentication Force-Authorized Vlan - Alaxala AX1250S Software Manual

web-authentication force-authorized vlan

web-authentication force-authorized vlan
When the RADIUS authentication method is used, this command forcibly changes the
status of a terminal to authentication authorized and assigns an authenticated VLAN if the
RADIUS server does not respond or a request to a RADIUS server fails due to route failure.
Input format
To set or change information:
web-authentication force-authorized vlan
To delete information:
no web-authentication force-authorized vlan
Input mode
(config-if)
Parameters
<VLAN ID>
Sets the authenticated VLAN ID to be assigned when authentication is permitted by
forced authentication.
1.
2.
[action trap]
When forced authentication is authorized, private traps are issued.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the
system-auth-control
440
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
See Specifiable values for parameters.
Note, however, that the default VLAN (
Default value when this parameter is omitted:
Private traps are not issued if forced authentication is authorized.
Range of values:
action trap
command is set.
<VLAN ID> [action trap]
VLAN ID = 1 ) cannot be set.
web-authentication