Table of Contents
Advertisement
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
A maximum of four RADIUS servers can be specified for each group.
2.
127.*.*.*
3.
The configuration of this command must meet both of the following conditions:
The value in this command is the same as the value in the
command (the values of
The
parameter has been set or the
configured).
4.
If multiple RADIUS servers are configured in the same RADIUS server group, the
address displayed by using the
primary RADIUS server in the RADIUS server group. This primary RADIUS server is
used as the first current server (the destination for RADIUS authentication requests).
The current server becomes the next RADIUS server in the primary RADIUS server
group.
Note that automatic restoration of the primary RADIUS server is governed by the
configuration of the
Related commands
aaa group server radius
dot1x authentication
mac-authentication authentication
radius-server host
web-authentication authentication
web-authentication user-group
cannot be specified as an IPv4 address.
auth-port
radius-server host
command configuration is enabled (the key
show radius-server
radius-server dead-interval
and
acct-port
are also the same).
radius-server key
command has been
operation command is the
command.
server
radius-server host
39
Advertisement
Table of Contents
