Spanning-Tree Single Forward-Time - Alaxala AX1250S Software Manual

spanning-tree single forward-time

Sets the time required for the state of a single spanning tree to change.
Input format
To set or change information:
spanning-tree single forward-time
To delete information:
no spanning-tree single forward-time
Input mode
(config)
Parameters
<Seconds>
Specify the time in seconds required for the state of a port to change.
If stp
state and the learning state are maintained for the specified period of time. If
rapid-stp
discarding state and the learning state are maintained for the set period of time (note
that this applies only when a timer causes the transition).
1.
2.
Default behavior
15 seconds is set as the time required for the state of a port to change.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
spanning-tree single mode
(802.1D) is set for the spanning-tree single mode
(802.1w) is set for the
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
4 to 30 (seconds)
<Seconds>
spanning-tree single mode
spanning-tree single forward-time
command, the listening
command, the
185