Table of Contents
Advertisement
dot1x vlan dynamic timeout supp-timeout
dot1x vlan dynamic timeout supp-timeout
Sets the time (in seconds) to wait for a response from a supplicant for an EAP-Request
packet sent to a supplicant. If no response is received, the EAP-Request packet is
retransmitted.
Input format
To set or change information:
dot1x vlan dynamic timeout supp-timeout
To delete information:
no dot1x vlan dynamic timeout supp-timeout
Input mode
(config)
Parameters
<Seconds>
Set the time (in seconds) to wait for a response from a supplicant.
1.
2.
Default behavior
30 seconds is used as the time to wait for a response from a supplicant.
Impact on communication
None
When the change is applied
When the operating timer times out (the value of the timer becomes 0).
When authentication processing starts
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Configuration commands and IEEE 802.1X authentication modes for the
authentication mode in which the command's settings are operable.
3.
This command takes effect only if the
been set.
Related commands
dot1x system-auth-control
426
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535 (seconds)
<Seconds>
dot1x system-auth-control
dot1x vlan dynamic enable
command has
Advertisement
Table of Contents
