Web-Authentication Logout Polling Retry-Interval - Alaxala AX1250S Software Manual

web-authentication logout polling retry-interval

Sets the interval between retransmissions of monitoring frames that periodically monitor the
connection status of authenticated terminals when a no-response state is detected.
Input format
To set or change information:
web-authentication logout polling retry-interval
To delete information:
no web-authentication logout polling retry-interval
Input mode
(config)
Parameters
<Seconds>
Sets the retransmission interval of monitoring frames.


Default behavior
1 second is set as the retransmission interval of monitoring frames.
Impact on communication
None
When the change is applied
The setting takes effect from the next retransmission interval.
Notes
1. All Web authentication settings take effect when the
system-auth-control
2. See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3. If the link for a monitored terminal goes down before periodic monitoring by the
functionality that monitors the connection of authenticated terminals arrives, the
Switch stops monitoring the terminal and logs it out due to its link-down state.
4. When the maximum connection time set by using the
max-timer
and logs it out.
5. If the number of retransmissions when a no-response state is detected is set to the
maximum, the number of monitoring frames increases proportionately with the
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 10 (seconds)
command is set.
command expires, the Switch stops monitoring the applicable terminal
web-authentication logout polling retry-interval
<Seconds>
web-authentication
web-authentication
459