Table of Contents
Advertisement
dot1x timeout quiet-period
dot1x timeout quiet-period
Sets the period of time (in seconds) for maintaining the unauthenticated state on the
applicable interface after an IEEE 802.1X authentication failure. During this period, no
EAPOL packets are sent and received EAPOL packets are ignored. Also, no authentication
processing is performed.
Input format
To set or change information:
dot1x timeout quiet-period
To delete information:
no dot1x timeout quiet-period
Input mode
(config-if)
Parameters
<Seconds>
Sets the period of time (in seconds) for maintaining the unauthenticated state.
1.
2.
Default behavior
60 seconds is used as the period for maintaining the unauthenticated state.
Impact on communication
None
When the change is applied
When the Switch enters an unauthenticated state due to an authentication failure.
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3.
The
port-control
Related commands
dot1x system-auth-control
dot1x port-control
402
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 65535 (seconds)
dot1x timeout tx-period
command has been set.
<Seconds>
dot1x system-auth-control
command takes effect only if the
dot1x
Advertisement
Table of Contents
