Alaxala AX1250S Software Manual page 406

dot1x force-authorized vlan

#1
#2
#3
#4
#5
#6
6. The forced authentication authorization state is canceled if authentication for the
applicable terminal is canceled.
7. If either of the following commands has already been set, this command cannot be
set:


382
All the following configurations have been set:
dot1x system-auth-control
-
- radius-server host
- dot1x port-control auto
- aaa authorized network default
dot1x vlan dynamic enable
-
dot1x vlan dynamic radius-vlan
-
vlan <VLAN ID>
-
switchport mac vlan
-
switchport mode mac-vlan
-
- dot1x force-authorized vlan
- aaa authentication dot1x
- dot1x authentication
Set this command when using port-based authentication (dynamic).
Set this command when using VLAN-based authentication (dynamic).
Set the same VLAN ID.
Set for the same interface.
The following accounting log data is collected when an authentication
-
request is sent to the RADIUS server:
No.=82
WARNING:SYSTEM:
RADIUS server.
<Additional information>: IP
You can use the
accounting log.
When forced authentication is used as the Switch default, set
.
radius
When forced authentication is used as the authentication method by port, set
aaa authentication dot1x
authentication force-authorized enable
authentication force-authorized vlan
or dot1x radius-server host
#1, #4
#2
#2
#2, #3
#3
mac-based
#2, #3, #4
#4
#3, #4
#5
#6
(<Additional information>)
show dot1x logging
<List name>.
Failed to connect to
command to check the
default group