Alaxala AX1250S Software Manual page 414

dot1x port-control
Notes
1. All IEEE 802.1X settings take effect when the
command is set.
2. See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3. When port-based authentication (static) is used, set the following commands for the
same interface (these commands can be set for Ethernet interfaces and port channel
interface):



4. When port-based authentication (dynamic) is used, pay attention to the following:


5. When the
arp-relay
command can be deleted if the following condition exists:

6. If the
authentication submode is single mode.
Related commands
dot1x system-auth-control
dot1x multiple-authentication
switchport mode
switchport access
switchport mac
390
dot1x port-control auto
switchport mode access
switchport access
If extended-authentication
command was set, this command cannot be set. (This command can be set if
the system function
Set the following commands for the same interface (these commands can be
set only for Ethernet interfaces):

dot1x port-control auto

switchport mode mac-vlan
authentication ip access-group
command has been set for the applicable port, the
web-authentication port
dot1x multiple-authentication
dot1x system-auth-control
was not set when the
command was not set.)
command or the a
or mac-authentication port
command has not been set, the
system function
uthentication
dot1x port-control
has been set.