Table of Contents
Advertisement
Index
36.1.10 Spanning tree information
Table 36-10 Spanning tree error messages
Message
Can not configure spanning-tree
when Ring Protocol is
configured.
Cost is over 65535, please set up
in 1 to 65535 or set pathcost
method to long.
Maximum number of entries are
already defined.
<STP_VLAN>
Maximum number of MST instance
are already defined.
Pathcost method is short, please
set up in 1 to 65535 or set
pathcost method to long.
Relations between
l2protocol-tunnel stp and
spanning-tree configuration are
inconsistent.
Relations between PVST+ and the
protocol-vlan or mac-vlan
configuration are inconsistent.
Too many parameters (VLAN-range
of MST Instance
<MSTI
36.1.11 Ring Protocol information
Table 36-11 Ring Protocol error messages
Message
axrp-<Ring
ID>: cannot
configure this command to
channel-group port.
axrp-<Ring
ID>: Can't delete
axrp configuration referred by
other.
666
Explanation
Spanning tree cannot be set because the Ring Protocol functionality
is set.
The value for
value from 1 to 65535 or set
The entry cannot be added because the maximum number of entries
has already been reached. Delete unnecessary entries, and then
add the new entry.
The number of MST instances has already reached the maximum
number. The maximum number of MST instances that can be set is
16.
short
is set for
65535 or set
The relations between the BPDU forwarding configuration and the
spanning tree configuration are inconsistent. When a BPDU
forwarding configuration is set, the spanning tree must be stopped.
PVST+ and a protocol VLAN or a MAC VLAN cannot be set at the
same time.
The number of input parameters exceeds the maximum number
ID>).
(200). Set a value equal to or smaller than the maximum number.
<MSTI
ID>: MST instance ID
Explanation
A ring port cannot be set for an interface that is participating in a port
channel.
<Ring
ID>: Ring ID
The specified ring ID cannot be deleted because it is being used by
axrp-ring-port
the
<Ring
ID>: Ring ID
cost
is equal to or greater than 65535. Sets the
long
for pathcost-method.
pathcost
method. Sets the
long
pathcost
method.
for
command.
cost
cost
value from 1 to
Advertisement
Table of Contents
