Channel-Group Max-Active-Port - Alaxala AX1250S Software Manual

channel-group max-active-port

Sets the maximum number of ports actually used in a channel group for link aggregation.
Input format
To set or change information:
channel-group max-active-port
To delete information:
no channel-group max-active-port
Input mode
(config-if)
Parameters
<Number>
Sets the maximum number of ports actually used in a channel group for link
aggregation. If the number of ports that is actually used in a channel group exceeds
the value set by this command, use only the number of ports that is specified and
apply the standby link functionality to the rest of the ports. If you use the standby link
functionality in link-not-down mode, set the
so, the standby link switches to the link-down stats. The methods for selecting the
standby link are as follows:


1.
2.
Default behavior
The maximum number is 8.
Impact on communication
The port in use is changed by the standby link functionality and communication might stop
temporarily.
When the change is applied
The change is applied immediately after setting values are changed.
[no-link-down]
Select a lower priority port by using the
If the priority is the same, select a port with a larger interface port number.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 8
<Number> [no-link-down]
command. If you do not do
no-link-down
lacp port-priority
channel-group max-active-port
command
103