Table of Contents
Advertisement
-
-
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2.
Range of values:
enable
Default behavior
None
Impact on communication
If sleep mode is set for a Switch, all communication stops when the scheduled power saving
time arrives.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If there is an overlap of time of execution between different
action disable
2.
When the
the following:
The Switch does not switch to the sleep state if the scheduled time of execution
arrives during operation in configuration command mode. After configuration
command mode ends with a switch to administrator mode, the Switch enters
the sleep state.
A configuration that is not saved is lost if the Switch switches to the sleep state.
As a result, the following messages appear when configuration command
mode ends:
Unsaved changes would be lost when the machine goes to sleep!
Do you exit "configure" without save ? (y/n):
Enter
When time is set for executing scheduled power saving, if the configuration
command has not ended, the Switch does not switch to the sleep state.
If no key input operations are performed for certain period of time (30 minutes by
default), you are automatically logged out. If you are automatically logged out
while editing the configuration and the Switch switches to the sleep state, an
unsaved configuration will be lost.
If the sleep state continues for 20 days, the sleep state is canceled and the
Switch is started. After the Switch starts, it switches to the sleep state again.
Related commands
None
power-control port cool-standby
shutdown
or
disable
setting has precedence.
schedule-power-control system-sleep
n
to save the changes, and then execute the
schedule-power-control time-range
action
parameters, the
command has been set, note
save
command.
67
Advertisement
Table of Contents
