Table of Contents
Advertisement
deny (ip access-list standard)
deny (ip access-list standard)
Sets the conditions for rejecting access in IPv4 address filtering.
Input format
To set or change information:
[
<Seq>
To delete information:
no
Input mode
(config-std-nacl)
Parameters
<Seq>
Sets the sequence in which filter conditions are applied.
1.
2.
<Src IPv4>
{
Sets the IPv4 address.
To set all IPv4 addresses, set
1.
2.
286
] deny {
<Src IPv4>
<Seq>
Default value when this parameter is omitted:
10 is set as the initial value if there are no conditions in the access list.
If conditions have been set, the initial value is the maximum value for the
application sequence that has been set plus 10.
Note, however, that if the maximum value for the application sequence is
greater than 4294967285, the value cannot be omitted.
Range of values:
Set 1 to 4294967295 (in decimal).
<Src IPv4 wildcard>
[
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify
<Src IPv4> [<Src IPv4 wildcard>
-
<Src IPv4> [<Src IPv4 wildcard>
Specify the IPv4 address for
For
[
<Src IPv4 wildcard>
that sets bits that permit an arbitrary value in an IPv4 address. If omitted,
the filter condition is a perfect match of
-
host
<Src IPv4>
The filter condition is a perfect match of
any
specification:
-
The IPv4 address is not included as a filter condition.
IPv4 address (nnn.nnn.nnn.nnn): 0.0.0.0 to 255.255.255.255
[
<Src IPv4 wildcard>
<Src IPv4>
] | host
any
.
]
,
host
]
specification:
<Src
IPv4>.
]
, specify a wildcard in IPv4 address format
specification:
] | host
<Src IPv4>
| any}
<Src
IPv4>, or
any
<Src
IPv4>.
<Src
IPv4>.
| any}
.
Advertisement
Table of Contents
