Table of Contents
Advertisement
ip qos-flow-group
ip qos-flow-group
Enables the QoS filtering functionality by applying an IPv4 QoS flow list to an Ethernet
interface or a VLAN interface.
Input format
To set information:
ip qos-flow-group
To delete information:
no ip qos-flow-group
Input mode
(config-if)
Parameters
<QoS flow list name>
Sets the IPv4 QoS flow list name.
1.
2.
in
Inbound is set.
in
: inbound (A receiver side setting)
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If
qos
cannot be set. (This command can be set if the
326
<QoS flow list name>
<QoS flow list name>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Set 3 to 31 characters, the first character of which must be a non-numeric
character. For details about the characters that can be specified, see
Specifiable values for parameters.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
None
was not set when the
system function
in
in
command was set, this command
system function
command was not
Advertisement
Table of Contents
