Table of Contents
Advertisement
Message
This list cannot be set to this
port.
This list cannot be set to VLAN.
This list name is being used as
other protocol type by other
definition.
36.1.19 Layer 2 authentication common information
Table 36-19 Error messages common to Layer 2 authentication
Message
interface : Invalid access-list
ID for authentication.
interface : Invalid
authentication
arp-relay
configuration.
interface : Invalid
authentication ip access-group
configuration.
interface : Over two entry as an
address family cannot be set.
Explanation
The QoS flow list cannot be applied to the applicable Ethernet
interface.
To apply a QoS flow list to an Ethernet interface, the VLAN ID of a
flow detection condition in the QoS flow list must be included in the
settings of the Ethernet interface to which you want to apply the list.
The QoS flow list cannot be applied to the VLAN interface.
If the VLAN ID is set as a flow detection condition in a QoS flow list,
the QoS flow list cannot be applied to the VLAN interface. Apply it to
an Ethernet interface or delete the VLAN ID from the detection
condition.
The name has already been used for another QoS flow list.
Specify a name that is not used for another QoS flow list or the target
QoS flow list.
Explanation
The access list is different from the one that has already been applied
authentication ip access-group
by using
can be applied).
Set an access list that has already been set. Alternatively, delete all
access lists that have already been applied to another interface, and
then set this again.
authentication arp-relay
following commands are set for the applicable port:
dot1x port-control
web-authentication port
mac-authentication port
Set any of the above commands for the applicable port, and then set
authentication arp-relay
authentication arp-relay
following commands are set for the applicable port:
dot1x port-control
web-authentication port
mac-authentication port
Set any of the above commands for the applicable port, and then set
authentication arp-relay
Another access list has already been applied.
Delete an existing access list, and then set this again.
(only one list name
cannot be set because none of the
again.
cannot be set because none of the
again.
Index
675
Advertisement
Table of Contents
