36.1.18 Qos Information - Alaxala AX1250S Software Manual

Configuration command reference
Hide thumbs Also See for AX1250S:
Table of Contents

Advertisement

Message
This list cannot be set to VLAN.
This list name is being used as
other protocol type by other
definition.
The maximum number of entries
are exceeded.

36.1.18 QoS information

Table 36-18 QoS error messages
Message
Can not set command, because
limit-queue-length command is
set.
Can not set command, because
scheduling modes is not PQ.
Can not set half duplex because
traffic-shape rate is specified
for the port.
Can not set half duplex because
WFQ min-rate is specified for
the port.
Can not set traffic-shape rate
because of the port is half
duplex.
Can not set WFQ min-rate because
of the port is half duplex.
Cannot attach this list because
flow detection mode Layer2-1.
Explanation
access list.
The access list cannot be applied to the VLAN interface.
If the VLAN ID is set as a flow detection condition in an access list,
the access list cannot be applied to the VLAN interface. Apply it to
an Ethernet interface or delete the VLAN ID from the detection
condition.
The identifier cannot be set because it is a name that has already
been used for another access list.
Specify a name that is not being used for another access list.
The number of specifiable entries was exceeded. Delete
unnecessary entries before executing the command.
Explanation
A scheduling mode other than PQ cannot be set because the
limit-queue-length
limit-queue-length
The
scheduling mode other than PQ is set.
Duplex mode cannot be set because port bandwidth control is set for
the line.
Duplex mode cannot be set because the minimum guaranteed
bandwidth of WFQ mode is set for the line.
Port bandwidth control cannot be set because the line is half duplex.
The minimum guaranteed bandwidth of WFQ mode cannot be set
because the line is half duplex.
If the flow detection mode is Layer 2-1, the QoS flow list cannot be
applied.
If the flow detection mode is Layer 2-1, a MAC QoS flow list can be
applied.
To do so, use the following command:
mac qos-flow-group
command is set.
command cannot be set because a
command
Index
673

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ax1240s

Table of Contents