36.1.28 Snmp Information - Alaxala AX1250S Software Manual

Message
interface : Exceeded the number
of the maximum port.
interface : Maximum number of
entries are already defined.
<CFM_MEP>
interface : Maximum number of
entries are already defined.
<CFM_MEP>
interface : MEP ID
already configured in cfm mep.
interface : Not found <Level>.
interface : Not found <No.>.
interface : this command is
different from this one in
channel-group port.

36.1.28 SNMP information

Table 36-29 SNMP error messages
Message
interface : Can not delete it
because data is not
corresponding.
interface : Maximum number of
entries are already defined.
<RMON_HISTRY_CTR>
interface : This configuration
has already been set.
Explanation
<Level>: Domain level
The number of ports for which MEPs and MIPs can be set has been
exceeded.
An attempt is being made to set a configuration that is larger than
the device capacity or to change a configuration in an environment
already at the maximum device capacity.
Delete configurations that are no longer used, and then set the
configuration again.
An attempt is being made to set a configuration that is larger than
the device capacity or to change a configuration in an environment
already at the maximum device capacity.
Delete configurations that are no longer used, and then set the
configuration again.
is
<MEPID> The specified MEP ID has already been set for another MEP.
<MEPID>: MEP ID
The specified domain level cannot be found. Make sure the domain
level has been set.
<Level>: Domain level
The specified MA identification number cannot be found.
Make sure the MA identification number has been set.
<No.>: MA identification number
Participation in the port channel is not possible because the
configuration is different.
Explanation
An attempt has been made to delete a non-existent identification
number. Check the identification number.
The maximum number that has been set has been exceeded.
Delete unnecessary entries.
When the
was found that the identification number was already being used by
another interface.
Either specify another identification number, or delete the
identification number being used by the other interface, and then set
rmon collection history
Index
command was being set, it
689