Ethernet Cfm Domain - Alaxala AX1250S Software Manual

ethernet cfm domain

Sets a domain. Executing this command switches to
domain name and MA can be set.
Input format
To set information:
ethernet cfm domain level
To delete information:
no ethernet cfm domain level
Input mode
(config)
Parameters
level <Level>
Sets the domain level.
1.
2.
direction-up
When up/down is not explicitly set by using the
set this parameter have the Switch operate in Up MEP mode.
1.
2.
3.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 7
Default value when this parameter is omitted:
The Switch operates in Down MEP mode.
Range of values:
None
Note on using this parameter:
This parameter cannot be changed. If you want to change the parameter,
delete the applicable command first, and then set the parameter.
config-ether-cfm
<Level> [direction-up]
<Level>
ethernet cfm mep
ethernet cfm domain
mode in which the
command, you can
605