Mac-Authentication Static-Vlan Roaming - Alaxala AX1250S Software Manual

mac-authentication static-vlan roaming

mac-authentication static-vlan roaming
Sets communication permissions (roaming) when the port for an authenticated terminal
changes to another port connected via a hub or similar means without a link-down event
occurring.
Input format
To set or change information:
mac-authentication static-vlan roaming [action trap]
To delete information:
no mac-authentication
Input mode
(config)
Parameters
[action trap]
When a change to another port due to roaming is detected, a private trap is issued.


Default behavior
Communication is not permitted when an authenticated terminal moves to another port.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All MAC-based authentication settings take effect when the
system-auth-control
2. See Configuration commands and MAC-based authentication modes for the
authentication mode in which the command's settings are operable.
3. If the destination port is a port in fixed VLAN mode and the move within the same
VLAN, communication is possible after the move.
4. If the DHCP snooping functionality is also used when this command is set and if the
port of an authenticated terminal changes to another port, the authentication status
also moves to the destination port. However, communication is impossible because
the binding database is not updated.
548
Default value when this parameter is omitted:
When a change to another port due to roaming is detected, a private trap is not
issued.
Range of values:
action trap
command is set.
static-vlan roaming
mac-authentication