Table of Contents
Advertisement
control-vlan
Sets the VLAN to be used as the control VLAN. You can use the VLANs set by using this
command to send and receive control frames that monitor the ring status.
Setting the
change the status of the control VLAN to
therefore adjust the time required before monitoring of the status of receiving flush control
frames on a transit node starts to ensure that the flush control frames sent by the master
node are received.
Input format
To set information:
control-vlan
To delete information:
no control-vlan
Input mode
(config-axrp)
Parameters
<VLAN ID>
Sets the VLAN to be used as the control VLAN.
1.
2.
forwarding-delay-time
Sets the time (in seconds) required before the control VLAN switches to
when a Switch is started in transit node.
1.
2.
3.
Default behavior
None
forwarding-delay-time
<VLAN ID>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
See Specifiable values for parameters.
Note, however, that the default VLAN (
using this command.
<Seconds>
Default value when this parameter is omitted:
The control VLAN is switched to
up.
Range of values:
1 to 65535 (seconds)
Notes on using this parameter:
To delete only this parameter, set
omitted. This operation has the effect of deleting parameter.
parameter allows you to set the time required to
Forwarding
during initial operation. You can
[forwarding-delay-time
VLAN ID = 1
Forwarding
control-vlan
<Seconds>
]
) cannot be specified by
Forwarding
immediately after a ring port is
again with this parameter
control-vlan
219
Advertisement
Table of Contents
