Lldp Hold-Count - Alaxala AX1250S Software Manual

lldp hold-count

Sets the time that a neighboring device retains an LLDP frame sent from a Switch.
Input format
To set or change information:
lldp hold-count
To delete information:
no lldp hold-count
Input mode
(config)
Parameters
<Count>
Sets the scaling for the value set by the
that a neighboring device retains the LLDP frame sent from a Switch. If the time
exceeds 65535, which is the maximum value, 65535 is used.
1.
2.
Default behavior
is set as the time that a neighboring device retains LLDP frames sent from a Switch.
4
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
lldp run
<Count>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
2 to 10
lldp interval-time command as the time
lldp hold-count
649