Dot1X Port-Control - Alaxala AX1250S Software Manual

dot1x port-control

Sets the port-control status for an interface that has been set. Entry of this command also
enables the IEEE 802.1X port-based authentication functionality.
Input format
To set or change information:
dot1x port-control {auto | force-authorized | force-unauthorized}
To delete information:
no dot1x port-control
Input mode
(config-if)
Parameters
{auto | force-authorized | force-unauthorized}
auto
force-authorized
force-unauthorized
1.
2.
Default behavior
The port-based authentication functionality is disabled.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
IEEE 802.1X authentication processing is performed. The authentication result
determines whether communication for the terminals connected to the
interface is possible.
IEEE 802.1X authentication is not performed, and communication by the
terminals connected to the interface that has been set is always possible. This
parameter can be set only if the mode for port-based authentication (static) is
single mode.
IEEE 802.1X authentication is not performed, and communication by the
terminals connected to the interface that has been set is never possible. This
parameter can be set only if the mode for port-based authentication (static) is
single mode.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
auto , force-authorized , or force-unauthorized
dot1x port-control
389