Table of Contents
Advertisement
dot1x vlan dynamic timeout tx-period
dot1x vlan dynamic timeout tx-period
Sets the interval (in seconds) for sending EAP-Request/Identity packets when IEEE 802.1X
authentication is valid.
Input format
To set or change information:
dot1x vlan dynamic timeout tx-period
To delete information:
no dot1x vlan dynamic timeout tx-period
Input mode
(config)
Parameters
<Seconds>
Set the interval (in seconds) for sending EAP-Request/Identity packets.
1.
2.
Default behavior
30 seconds is used as the interval for sending EAP-Request/Identity packets.
Impact on communication
None
When the change is applied
When the operating timer times out (the value of the timer becomes 0).
When the
authentication at the authentication level or the Switch level.
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Configuration commands and IEEE 802.1X authentication modes for the
authentication mode in which the command's settings are operable.
3.
This command takes effect only if the
been set.
4.
For the parameter, set a value smaller than the value set by using the
dynamic timeout reauth-period
428
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 65535 (seconds)
clear dot1x auth-state
<Seconds>
operation command is executed to cancel
dot1x system-auth-control
dot1x vlan dynamic enable
command.
command has
dot1x vlan
Advertisement
Table of Contents
