Spanning-Tree Single Mode - Alaxala AX1250S Software Manual

spanning-tree single mode

spanning-tree single mode
Sets the operating mode of single spanning trees.
Input format
To set or change information:
spanning-tree single mode { stp | rapid-stp }
To delete information:
no spanning-tree single mode
Input mode
(config)
Parameters
{ stp | rapid-stp }
Sets the protocol to be used. If the protocol is changed during spanning tree
operation, the spanning tree is re-initialized. If
If
rapid-stp
1.
2.
Default behavior
is set as the spanning-tree operating mode.
stp
Impact on communication
If the spanning-tree single
communication until the topology is formed.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None
188
is set, rapid spanning tree mode is used.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
stp or rapid-stp
command is set, recalculation of the topology interrupts
is set, spanning tree mode is used.
stp