36.1.25 Storm Control Information; 36.1.26 L2 Loop Detection Information; 36.1.27 Cfm Information - Alaxala AX1250S Software Manual

this command is different from
this one in channel-group port.
Too many parameters
(exclude-VLAN ).

36.1.25 Storm control information

Table 36-26 Storm control error messages
Message
Please lower the recovery
threshold than the detection
threshold.

36.1.26 L2 loop detection information

Table 36-27 L2 loop detection error messages
Message
L2LD : Can't setting port[<IF#>]
because of channel-group port.
this command is different from
this one in channel-group port.

36.1.27 CFM information

Table 36-28 CFM error messages
Message
ethernet : Can not delete it
because data is not
corresponding.
ethernet : Cannot change cfm
domain direction.
ethernet : Can't delete this
configuration referred by other
configuration.
Participation in the port channel is not possible because the
configuration is different.
The number of input parameters exceeds the maximum number
(200). Set a value equal to or smaller than the maximum number.
Explanation
A value that is greater than the storm detection threshold is specified
for the recovery-from-storm threshold. For the recovery-from-storm
threshold, set a value equal to or smaller than the storm detection
threshold.
Explanation
loop-detection
The command configuration cannot be changed
because the specified port number belongs to a channel group.
<IF#>: Interface port number
Participation in the channel group is not possible because the
loop-detection
setting is different.
Explanation
Deletion is not possible because the specified configuration does
not exist or duplicate data exists.
The MEP direction that is set in a domain cannot be changed.
Delete the applicable command, and then set this again.
The configuration cannot be changed because it is referenced by
another configuration.
Delete the configuration referenced by another configuration, and
then set this again.
Index
687