Table of Contents
Advertisement
mac access-group
Notes
1.
If
filter
cannot be set. (This command can be set if the
set.)
2.
One MAC filter can be set for one interface. A maximum of 128 filters can be applied
to an Ethernet interface or a VLAN interface. If a filter has already been set, first
remove it, and then set it again.
3.
If a non-existent MAC filter is set, no operation is performed. The identifier of a MAC
access list is registered.
4.
The flow detection mode that can be set is Layer 2-1. The following table describes
whether an interface can be set.
Table 19-10 Specifiable interfaces for each flow detection mode
Flow detection mode
Layer2-1
Layer2-2
Legend Y: Can be set; N: Cannot be set
5.
When a MAC filter is applied to an Ethernet interface, the flow detection mode can be
set if a VLAN parameter exists as a flow detection condition and the VLAN ID is
included in the Ethernet interface settings.
6.
When a MAC filter is applied to a VLAN interface, the flow detection mode can be set
if no VLAN parameters are included as a flow detection condition.
Related commands
mac access-list extended
300
was not set when the
system function
Whether the mode can be set
Ethernet
Y
N
command was set, this command
system function
command was not
VLAN
Y
N
Advertisement
Table of Contents
