Table of Contents
Advertisement
ethernet cfm mep
1.
2.
3.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If the
to or higher than the
2.
This command cannot be set for an Ethernet interface that is set for a channel group.
Also, an Ethernet interface set by using this command cannot be set for a channel
group. Set this command for the port channel interface to which the applicable
Ethernet interface belongs.
Related commands
ethernet cfm domain
610
maintained.
Default value when this parameter is omitted:
When
direction-up
command, Up MEP is used. If it has not been set, Down MEP is used.
Range of values:
or
down
up
Note on using this parameter:
This parameter cannot be changed. If you want to change this parameter,
delete this configuration first, and then reset it.
command is set on the same interface, a domain level equal
ethernet cfm mip
ethernet cfm mip
has been set by using the
command cannot be set.
ethernet cfm domain
Advertisement
Table of Contents
