Table of Contents
Advertisement
qos (ip qos-flow-list)
qos (ip qos-flow-list)
Sets flow detection conditions and operation settings in an IPv4 QoS flow list.
Input format
To set or change information:
[
<Seq>
When upper-layer protocols are other than TCP and UDP
When an upper-layer protocol is TCP
When an upper-layer protocol is UDP
To delete information:
no
Input mode
(config-ip-qos)
Parameters
<Seq>
Sets the application sequence in the QoS flow list to be created or changed.
1.
2.
338
] qos {
<Flow detection conditions>
<Flow detection conditions>
{ip |
<Protocol>
| icmp | igmp } {
<Src IPv4>
| any}{
[{ [tos
<TOS>
] [precedence
<VLAN ID>
] [user-priority
tcp {
<Src IPv4> <Src IPv4 wildcard>
port>
<Dst IPv4> <Dst IPv4 wildcard>
] {
port>
] [ack] [fin] [psh] [rst] [syn] [urg] [{ [tos
[precedence
<Precedence>
<Priority>
[user-priority
udp {
<Src IPv4> <Src IPv4 wildcard>
port>
<Dst IPv4> <Dst IPv4 wildcard>
] {
port>
<TOS>
] [{ [tos
[vlan
<VLAN ID>
] [user-priority
<Operation settings>
action [cos
<COS>
<DSCP>
[replace-dscp
<Seq>
Default value when this parameter is omitted:
10 is set as the initial value if there are no conditions in the QoS flow list.
If conditions have been set, the initial value is the maximum value for the
application sequence that has been set plus 10.
Note, however, that if the maximum value for the application sequence is
greater than 4294967285, the value cannot be omitted.
Range of values:
Set 1 to 4294967295 (in decimal).
} [
<Operation settings>
<Src IPv4> <Src IPv4 wildcard>
<Dst IPv4> <Dst IPv4 wildcard>
<Precedence>
<Priority>
]
| host
| host
] | dscp
<DSCP>
]
| host
| host
<Precedence>
] [precedence
<Priority>
] [replace-user-priority
]
]
| host
<Dst IPv4>
] | dscp
<DSCP>
}] [vlan
<Src IPv4>
| any} [eq
<Dst IPv4>
| any} [eq
<TOS>
]
}] [vlan
<VLAN ID>
<Src IPv4>
| any} [eq
<Dst IPv4>
| any} [eq
<DSCP>
] | dscp
]
<Priority>
]
| host
| any}
<Src
<Dst
]
<Src
<Dst
}]
Advertisement
Table of Contents
