Ip Dhcp Snooping Database Write-Delay - Alaxala AX1250S Software Manual

ip dhcp snooping database write-delay

ip dhcp snooping database write-delay
Sets the wait-to-write time used when a binding database is saved.
Input format
To set or change information:
ip dhcp snooping database write-delay
To delete information:
no ip dhcp snooping database write-delay
Input mode
(config)
Parameters
<Seconds>
Sets the wait-to-write time used when a binding database is saved.
1.
2.
Default behavior
When ip dhcp snooping database url
Impact on communication
None
When the change is applied
The setting takes effect at the next save event after the setting value has been changed.
Notes
1. For the wait-to-write time set by using this command, any of the save events below
causes the timer to start. When the timer expires, the binding database is saved.



If the Switch power is turned off before the timer expires, the binding database cannot
be saved.
2. If the
by using the
binding database is not saved.
238
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1800 to 86400 (seconds)
A dynamic binding database is registered, updated, or deleted.
The ip dhcp snooping database url
to the save destination).
The
clear ip dhcp snooping binding
no ip dhcp snooping database url
ip dhcp snooping database write-delay
<Seconds>
is set, 1800 (seconds) is used.
command is set (this includes changes
operation command is executed.
command is entered after the timer set
command has started, the