Table of Contents
Advertisement
web-authentication authentication
Sets the name of an authentication method list for the port-based authentication method.
Input format
To set or change information:
web-authentication authentication
To delete information:
no web-authentication authentication
Input mode
(config-if)
Parameters
<List name>
Specify the authentication method list name set by using the
web-authentication
1.
2.
Default behavior
Web authentication uses the default values of the Switch.
Impact on communication
Authentication of a terminal for a port whose authentication method list name has been
changed is canceled.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All Web authentication settings take effect when the
system-auth-control
2.
See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3.
If at least one of the following commands is set for a Switch, this command cannot be
set:
command.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Specify a character string that is no more than 32 characters. For details about
the characters that can be specified, see Specifiable values for parameters
(with the exception of the at mark (
We recommend that you use an upper-case letter for the first character.
command is set.
dot1x vlan dynamic enable
web-authentication authentication
<List name>
aaa authentication
@
)).
web-authentication
437
Advertisement
Table of Contents
