web-authentication logout polling count
5.
If the number of retransmissions when a no-response state is detected is set to the
maximum, the number of monitoring frames increases proportionately with the
number of authenticated users, overloading the Switch.
Set the polling interval by using the following formula as a guide:
Polling condition:
(1) Polling interval > (2) Retransmission interval x (3) Number of retransmissions
Related commands
web-authentication system-auth-control
web-authentication max-timer
web-authentication port
web-authentication logout polling enable
web-authentication logout polling interval
web-authentication logout polling retry-interval
454
(1):
web-authentication logout polling interval
(2):
web-authentication logout polling retry-interval
(3):
web-authentication logout polling count
We recommend you use the default value for the number of retransmissions.
If a large value is set as the number of retransmissions, the difference between
the polling interval and retransmission interval might increase depending on
the retransmission frequency.