switchport backup mac-address-table update retransmit
Specifies the number of re-transmissions of MAC address update frames.
Input format
To set or change information:
switchport backup mac-address-table update retransmit
To delete information:
no switchport backup mac-address-table update retransmit
Input mode
(config-if)
Parameters
<Count>
Sets the number of re-transmissions of MAC address update frames when the
primary port and the secondary port are switched.
1.
2.
Default behavior
MAC address update frames are not re-transmitted.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If the setting is changed while MAC address update frames are being transmitted, the
new value is applied from the next time values are transmitted.
2.
Setting the
enables this command.
3.
Set this command for the primary port.
Related commands
switchport backup interface
switchport backup mac-address-table update transmit
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 3 (times)
switchport backup mac-address-table update transmit
switchport backup mac-address-table update retransmit
<Count>
command
571