Table of Contents
Advertisement
line vty
Permits Telnet remote access to the Switch. This command is also used to limit the number
of users that can be logged in remotely to a Switch at the same time.
Configuration with this command allows remote access using the Telnet protocol from any
remote operation terminal to be accepted. To limit access, set
transport input
Input format
To set or change information:
line vty
To delete information:
no line vty
Input mode
(config)
Parameters
<Start allocation>
Sets permission for remote login.
<End allocation>
Sets the number of users who are able to log in.
1.
2.
Default behavior
Does not accept remote access that uses the Telnet protocol.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
.
<Start allocation> <End allocation>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 (fixed)
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
0 to 1 (The number of users able to log in can be set to 1 or 2 users.)
ip access-group
and
line vty
11
Advertisement
Table of Contents
