Web-Authentication Static-Vlan Force-Authorized - Alaxala AX1250S Software Manual

web-authentication static-vlan force-authorized

web-authentication static-vlan force-authorized
When the RADIUS authentication method is used, this command forcibly changes the
status of a terminal that requests authentication on the applicable port to authentication
authorized if the RADIUS server does not respond or a request to the RADIUS server fails
because of a route failure or other problem.
Input format
To set or change information:
web-authentication static-vlan force-authorized [action trap]
To delete information:
no web-authentication static-vlan force-authorized
Input mode
(config-if)
Parameters
[action trap]
When forced authentication is authorized, private traps are issued.


Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. All Web authentication settings take effect when the
system-auth-control
2. See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3. Be especially careful when using this functionality, as it might pose a security
problem.
4. This command is enabled when the following condition exists:

480
Default value when this parameter is omitted:
Private traps are not issued if forced authentication is authorized.
Range of values:
action trap
command is set.
All the following configurations have been set:
- radius-server host
web-authentication
or web-authentication radius-server host