Table of Contents
Advertisement
dot1x vlan dynamic radius-vlan
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3.
This command takes effect only if the
been set.
4.
The
has been set.
5.
A maximum of 256 VLANs can be set for VLAN-based authentication (dynamic).
6.
If none of the VLANs that falls within the range can be set, an error occurs.
7.
If at least one of the following commands is set for a Switch, this command cannot be
set:
Related commands
vlan
dot1x system-auth-control
dot1x vlan dynamic enable
switchport mac
416
Specifiable values for parameters. Note that the default VLAN (
cannot be set by using this command.
<VLAN ID list>
parameter can be set only for the VLAN ID of a MAC VLAN that
authentication multi-step
dot1x authentication
mac-authentication authentication
web-authentication authentication
web-authentication user-group
dot1x system-auth-control
dot1x vlan dynamic enable
VLAN ID = 1
)
command has
Advertisement
Table of Contents
