Ip Arp Inspection Trust - Alaxala AX1250S Software Manual

ip arp inspection trust

ip arp inspection trust
Sets the applicable interface as a trusted port where no dynamic ARP inspection is
performed when the DHCP snooping functionality is enabled on a Switch.
Input format
To set information:
ip arp inspection trust
To delete information:
no ip arp inspection trust
Input mode
(config-if)
Parameters
None
Default behavior
Dynamic ARP inspection is performed.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. On an interface on which this command is set, if the interface is accommodated in the
VLAN where the dynamic ARP inspection functionality is enabled, the inspection is
not performed.
2. The ARP packet reception rate of the interface on which this command is set has no
limit.
Related commands
ip dhcp snooping
ip dhcp snooping vlan
230