power inline allocation
power inline allocation
Sets power allocation for each port either based on its class or manually.
Input format
To set or change information:
power inline allocation {auto | limit
To delete information:
no power inline allocation
Input mode
(config-if)
Parameters
auto
Detects a power-receiving device and automatically categorizes power classes, and
sets the amount of power allocated to the applicable port based on its class.
The following table lists the power classes and the maximum output power for each.
Power class
Class0
Class1
Class2
Class3
Class4
limit
Detects a power-receiving device and automatically categorizes power classes, and
sets the amount of power allocated to the applicable port manually.
<Threshold>
Default behavior
auto
is set.
92
Maximum output power
15.4 W
4.0 W
7.0 W
15.4 W
30.0 W
Sets the amount of power for a port and the amount of power consumption to
be used for priority control in steps of 200 mW. This parameter becomes valid
when
limit
is specified.
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2.
Range of values:
4000 to 30000 (mW)
<Threshold>}