Table of Contents
Advertisement
aaa authorization network default
aaa authorization network default
Set this command to perform VLAN-based authentication (dynamic) according to the VLAN
information set by using an authentication method.
Input format
To set information:
aaa authorization network default group radius
To delete information:
no aaa authorization network default
Input mode
(config)
Parameters
group radius
IEEE 802.1X authentication is performed by a RADIUS server.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
All IEEE 802.1X settings take effect when the
command is set.
2.
See Table 22-1 Configuration commands and IEEE 802.1X authentication modes for
the authentication mode in which the command's settings are operable.
3.
If this command is not set, VLAN-based authentication (dynamic) cannot be used.
Related commands
dot1x system-auth-control
dot1x vlan dynamic enable
aaa authentication dot1x
radius-server host
374
or
dot1x radius-server host
dot1x system-auth-control
Advertisement
Table of Contents
