Dot1X Supplicant-Detection - Alaxala AX1250S Software Manual

dot1x supplicant-detection

Sets the behavior when a new terminal is detected after the terminal authentication mode
has been set to an authentication submode.
Input format
To set or change information:
dot1x supplicant-detection {disable | shortcut | auto}
To delete information:
no dot1x supplicant-detection
Input mode
(config-if)
Parameters
{disable | shortcut | auto}
Sets the behavior when a new terminal is detected after terminal authentication mode
has been set as the authentication submode.
disable
shortcut
auto
1.
2.
Default behavior
shortcut
Suppresses EAP-Request/Identity transmission processing for detecting a
new terminal when the authentication submode has been set to terminal
authentication mode. Set this parameter in cases when a supplicant that
operates abnormally due to omission of the authentication sequence in order
to decrease Switch load is used.
If this parameter is set, authentication processing for a supplicant for which
authentication cannot be initiated from the terminal cannot be started.
Sends EAP-Request/Identity packets regularly in multicast routing for
detecting a new terminal when the authentication submode is set to terminal
authentication mode. Also, to reduce the load, the authentication sequence of
an authenticated terminal is omitted. Set this parameter for a supplicant that is
unable to initiate authentication from a terminal.
If this parameter is set, some supplicants do not operate correctly and
communication temporarily stops.
Suppresses EAP-Request/Identity transmission processing for detecting a
new terminal when the authentication submode is set to terminal
authentication mode, and sends EAP-Request/Identity packets in unicast
routing when an ARP/IP frame is received from a new terminal.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
disable , shortcut , or
is used as the operation when a new terminal is detected.
auto
dot1x supplicant-detection
397