Spanning-Tree Vlan Mode - Alaxala AX1250S Software Manual

spanning-tree vlan mode

Sets the PVST+ operating mode.
Input format
To set or change information:
spanning-tree vlan
To delete information:
no spanning-tree vlan
Input mode
(config)
Parameters
<VLAN ID list>
Starts configuration of PVST+ for the specified VLAN.
1.
2.
{ pvst | rapid-pvst }
Sets the protocol to be used. If the protocol is changed during spanning tree
operation, the spanning tree is re-initialized. If
rapid-stp
1.
2.
Default behavior
The PVST+ operating mode uses the setting of
Impact on communication
If or
pvst
of the topology interrupts communication until the topology is formed.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
<VLAN ID list>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
For details about how to set
Specifiable values for parameters.
is set, rapid PVST+ mode is used.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
or
pvst rapid-stp
has been set for the
rapid-pvst
mode { pvst | rapid-pvst }
<VLAN ID list> mode
<VLAN ID list>
pvst
spanning-tree mode
spanning-tree mode
spanning-tree vlan mode
and the specifiable values, see
is set, PVST+ mode is used. If
command.
command, recalculation
203