bandwidth
Sets the bandwidth of a line.
Input format
To set or change information:
bandwidth
To delete information:
no bandwidth
Input mode
(config-if)
Parameters
<kbit/s>
Sets the line bandwidth in kbit/s.
This setting is used for the
applicable line, and has no impact on communication.
1.
2.
Default behavior
The line speed of the applicable line is the bandwidth.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Related commands
None
<kbit/s>
ifSpeed
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
1 to 100000 (kbit/s for
1 to 1000000 (kbit/s for
Do not specify a value that exceeds the line speed of the applicable line.
/
ifHighSpeed
(SNMP MIB) value of the
interface fastethernet
interface gigabitethernet
bandwidth
)
)
75