disable
Disables the Ring Protocol functionality.
Input format
To set information:
disable
To delete information:
no disable
Input mode
(config-axrp)
Parameters
None
Default behavior
The Ring Protocol functionality is enabled.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If this command is entered while the Ring Protocol is operating, the Ring Protocol
functionality is disabled. In this case, a loop might occur depending on a network
configuration (ring configuration) to which the Ring Protocol functionality is applied.
To prevent looping before entering this command, place the interface that is the ring
port in the shutdown state.
Related commands
None
disable
221