Table of Contents
Advertisement
ipv6 mld snooping mrouter
Sets a multicast router port for the VLAN interface.
Input format
To set or change information:
ipv6 mld snooping mrouter interface {fastethernet
gigabitethernet
To delete information:
no ipv6 mld snooping mrouter interface {fastethernet
gigabitethernet
Input mode
(config-if)
Parameters
{fastethernet
Sets an interface for a multicast router port that has been set.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after the setting value is changed.
Notes
1.
If
ipv6 mld snooping
operate.
2.
To connect a Switch to a multicast router port, enable the MLD snooping functionality
on the destination Switch.
3.
If you specify a port number belonging to a port channel for a multicast router port, no
operation is performed.
<IF#>
| port-channel
<IF#>
| port-channel
<IF#>
| gigabitethernet
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
<IF#>: Specify an interface port number belonging to the VLAN.
<Channel
group#>: Specify a channel group number belonging to the VLAN.
For details about the specifiable values, see Specifiable values for parameters.
is not set for the applicable interface, this functionality does not
<Channel group#>
<Channel group#>
<IF#>
| port-channel
ipv6 mld snooping mrouter
<IF#>
|
}
<IF#>
|
}
<Channel group#>
}
259
Advertisement
Table of Contents
