Table of Contents
Advertisement
Notes
1.
All Web authentication settings take effect when the
system-auth-control
2.
See Configuration commands and Web authentication modes for the authentication
mode in which the command's settings are operable.
3.
If three or more Web authentication RADIUS servers are configured and another
Web authentication RADIUS server becomes the current server after the monitoring
timer starts, the monitoring timer is not reset and continues to run.
4.
In general, when the monitoring timer has started, it does not reset until it expires.
However, as exceptions, it resets in the following cases:
When
web-authentication radius-server dead-interval
When information about the Web authentication RADIUS server operating as
the current server is deleted by using the
radius-server host
When the
5.
If the monitoring timer expires while the authentication sequence is being executed
on a terminal subject to authentication, restoration of the primary Web authentication
RADIUS server is not performed until the executed authentication sequence is
completed.
Related commands
aaa authentication web-authentication
web-authentication port
web-authentication system-auth-control
web-authentication radius-server host
command is set.
web-authentication dead-interval 0
configuration command
clear radius-server
web-authentication radius-server dead-interval
web-authentication
is configured by using the
web-authentication
operation command is executed
command
469
Advertisement
Table of Contents
