Table of Contents
Advertisement
loop-detection auto-restore-time
Sets the time required for automatic activation of a blocked port.
Input format
To set or change information:
loop-detection auto-restore-time
To delete information:
no loop-detection auto-restore-time
Input mode
(config)
Parameters
<Seconds>
Sets the time (in seconds) required for automatic activation of a blocked port.
1.
2.
Default behavior
The blocked port is not activated automatically.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
When this command has been set and the parameter is changed, if time remains until
the port is activated automatically, the change becomes operational only after the
remaining time has been cleared.
Related commands
loop-detection enable
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
60 to 86400 (seconds)
loop-detection auto-restore-time
<Seconds>
587
Advertisement
Table of Contents
