qos-queue-list
2.
If the line status is half duplex and WFQ is set, WFQ is not used for operation. Instead,
PQ is used.
3.
If WFQ is set, there might be a maximum error of 10% between the set minimum
bandwidth and the actual value.
4.
To use port bandwidth control and scheduling of QoS queue list information at the
same time, set PQ as the scheduling mode.
5.
If
wfq
will be used.
6.
When the bandwidth is set in Mbit/s
show running-config
Related commands
qos-queue-group
354
is selected as the scheduling mode,
and
<Min rate>
(<Mbit/s>
M
), the value is displayed in kbit/s for
show startup-config
must be set for the queues that
.