Table of Contents
Advertisement
mac access-group
Applies a MAC access list to an Ethernet interface or a VLAN interface and enables the
MAC filtering functionality.
Input format
To set information:
mac access-group
To delete information:
no mac access-group
Input mode
(config-if)
Parameters
<ACL ID>
Sets the identifier of the MAC packet filter that is to be set.
1.
2.
in
Inbound is set.
in
: inbound (A receiver side setting)
1.
2.
Default behavior
None
Impact on communication
When an access list with at least one entry is applied to an interface, all packets received at
the interface are discarded temporarily until the entry is applied to the interface.
When the change is applied
The change is applied immediately after setting values are changed.
<ACL ID>
<ACL ID>
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Set 3 to 31 characters, the first character of which must be a non-numeric
character. For details about the characters that can be specified, see
Specifiable values for parameters.
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
None
in
in
mac access-group
299
Advertisement
Table of Contents
