Mac Access-List Extended - Alaxala AX1250S Software Manual

mac access-list extended

Sets the access list to be used as a MAC filter. An access list used for a MAC filter filters
packets based on source MAC address, destination MAC address, Ethernet type number,
VLAN ID, and user priority.
Multiple filter conditions can be set by using a single access list ID. For an Ethernet interface
and a VLAN interface, a maximum of 127 filter conditions can be set. For a Switch, a
maximum of 1024 access lists (for IPv4 and MAC) can be created. A maximum of 1024 filter
condition entries can be created.
Input format
To set or change information:
mac access-list extended
To delete information:
no mac access-list extended
Input mode
(config)
Parameters
<ACL ID>
Sets the identifier of the MAC packet filter that is to be set. The Switch enters
config-ext-macl mode.
Names that have already been used for IPv4 address filters and IPv4 packet filters
cannot be set.
1.
2.
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
None
Default value when this parameter is omitted:
This parameter cannot be omitted.
Range of values:
Set 3 to 31 characters, the first character of which must be a non-numeric
character. For details about the characters that can be specified, see
Specifiable values for parameters.
<ACL ID>
<ACL ID>
mac access-list extended
301