Table of Contents
Advertisement
#1: 1 M = 1000 k.
#2: Set values that are 1000 k or greater in 100 k increments (1000 k, 1100 k, 1200
k...10000000 k).
#3: Set values that are less than 1000 k in 64 k increments (64 k, 128 k, 192 k...960 k).
Default behavior
The send bandwidth is not limited.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
There might be a maximum error of 10% between the set port bandwidth value and
the actual value.
2.
When the line status is half duplex, port bandwidth control is not supported.
3.
To use port bandwidth control and scheduling of QoS queue list information at the
same time, set PQ as the scheduling mode.
4.
When the bandwidth is set in Mbit/s
show running-config
5.
When the set bandwidth for port bandwidth control exceeds the line speed, the port
bandwidth is not controlled.
Related commands
interface fastethernet
interface gigabitethernet
(<Mbit/s>
M
and
show startup-config
), the value is displayed in kbit/s for
.
traffic-shape rate
357
Advertisement
Table of Contents
